|
download Installation Instructions. Read Me! 1. DISCONNECT NEGATIVE (-) BATTERY CABLE. 2. Remove air intake assembly. 3. Remove throttle body intake box and save bolts. 4. Remove (3) bolts from throttle body. 5. Remove bolts from throttle linkage bracket and save. 6. Install power plate using (3) 6mm x 60 bolts and (3) 6mm flat washers. (Ref. “A”) 7. Locate (3) extension plates (short) and (3) 6mm x 20mm flat head screws before installing throttle linkage and dipstick bracket. * Please Note: Remove the stud from front throttle linkage mount. The dipstick must be located under forward extension plate at flathead screw location
|
|
|
download Dodge/Chrysler DTC Reader Instructions PLEASE READ THIS ENTIRE INSTRUCTION SHEET BEFORE YOU PROCEED DTC CODE READER OPERATION The Superchips MAX MicroTuner is equipped to function as a Diagnostic Trouble Code Reader for Dodge and Chrysler OBDII equipped vehicles. Using the keypad on the MAX MicroTuner, you can read and reset logged DTCs. Using the chart of DTCs that follows, you can interpret each of the DTCs
|
|
|
download The Data Link connector is located in different locations based on the year of the truck: • 98.5-99 the triangle shaped connector is located on the drivers side of the engine in the wiring harness near the power steering pump • 2000-2001 the three prong flat connector is located on top of the fuel lift pump that is located on the driver’s side of the engine directly below the MAP sensor, note: on some 2001 truck’s the connector is located on the drivers side of the engine in the wiring harness near the power steering pump 3. A plug is installed in the data link connector on the truck to resist corrosion, remove this and install the supplied connector
|
|
|
|
<< Start < Prev 1 2 3 4 5 6 Next > End >>
|
| Results 36 - 42 of 42 |
